User's Manual

545C Operations Manual

02/10/2012 Prerelease DCN 00001789-A

Displays the current event and group table when no additional parameters

are attached. All the event commands begin with “event,” followed by

parameters.

Command: EVENT, DEL, ALL

Delete all events in the event table. Event table commands should be

edited in script files and output to the MCC-545C using XTermW in order to

reload the event table. This command does not delete the text messages or

group definitions.

Command: EVENT, DEL, number

Delete only the numbered event from the event table. The events will be

renumbered when one is deleted. Event table commands should be edited

in script files and output to the MCC-545C using XTermW in order to reload

the event table.

Command: EVENT, START

Start the event scanner. Scanned events will not be detected unless

scanning is started. This command causes the event scanner to review the

event table every 62.5 milliseconds for the occurrence of scanned events

and the end of scanned events. This command also performs RESET events.

On MCC-545C reset, the event scanner is started.

Command: EVENT, STOP

Stop the event scanner. Scanned events will not be detected while

scanning is stopped. This command should be issued prior to clearing the

event table (EVENT,DEL,ALL) and reprogramming it with events. This

command does not affect the detection of the reset event. On MCC-545C

reset, the event scanner is started again if the SAVE command was not

issued while in the EVENT,STOP state.

Command: EVENT, action

A direct command for immediate action can be issued. This event

command will not be added to the event table, but will cause the action to

occur when the command is entered. This can be used to take action using