Instruction Manual

OPERATIONS 4-29
MCC-545C PACKET DATA RADIO
12/2000
MCC-545C COMMANDS
COMMAND DESCRIPTION PARAMETERS RANGE
FLUSH TXQ,nnnn Delete all elements of specified Station from transmit
queue.
nnnn = Station ID
Master = 1 – 245
Remote = 256 –
4095
1 – 4095
*FREQ{UENCIES}{,Tx,
Rx}
Set operating frequencies of the MCC-545C/S.
Componentry in the MCC-545C/S limits the usable
frequency range to a 2 MHz bandwidth. If frequencies
are to be changed outside this bandwidth, hardware
modifications must also be made. The Frequency
Synthesizer must be enabled via the SYNTH,ON
command for FREQ{UENCIES} to have any effect.
This command is meaningless on an MCC-545C.
Tx = Tx
frequency in MHz
times 100
Rx = Rx
frequency in MHz
times 100
4000 – 5000
4000 – 5000
*FULL DUPLEX
Set MCC-545C in full-duplex mode.
IMPORTANT
When set to full-duplex mode, the MCC-545C’s receiver
is disabled by the built-in Tx/Rx switch.
†GLOF{,nnnn,nnnn} Define the IDs for use as GLOF sensor Stations/display
total GLOF setup.
nnnn = Station ID
Master = 1 – 245
Remote = 256 –
4095
OFF disables
GLOF sensor
Stations
1 – 4095
†GLOF
MONITOR,t,action
Setup timeout (in seconds) and action for the GLOF
MONITOR Station
t = timeout in
seconds
action = ALERT,
FLOOD
10 – 3600