Instruction Manual

OPERATIONS 4-19
MCC-545C PACKET DATA RADIO
12/2000
4.9 Command Reference List
MCC-545C COMMANDS
All implemented MCC-545C commands are listed in Table 4.2 alphabetically for ease of
reference. However, many commands are used in conjunction with others. These functional
groups are given below. You may also type HELP or HELP,COMMAND to receive an
explanation of any listed command. Command responses and unsolicited printouts are shown in
Appendix A.
STATION CONFIGURATION
COMMANDS
STATUS
COMMANDS
MESSAGE
COMMANDS
†*ASSIGN †RCT BINS CANMSG
*BRATE †REMOTE TYPE CLS CANMSG MODE
*CHECKIN †RXTYPE CONFIG CANMSG OFF
†CLOSE PORT SAVE *HOURLIES †COMPRESSION
†CONNECT †SCALE MEM DEL MSG
DATE †SCHED MODE DQE RXQ
*DESTINATION SERIAL †MON DQE TXQ
*DEVICE *SET BAUD †MONOFF FLUSH MSG
*DUTY CYCLE †*SNP †NETMON FLUSH RXQ
*FREQUENCIES *SOURCE RELAY STAT FLUSH TXQ
†HOST MODE †START *STAT TIME *HOLD
†*ID †STOP T MESSAGE
†LOGOFF †STT TEST *MSG
†LOGON †SUBST *PRINT
*LOS CHECKIN *SYNTH REMCMD
*MODULATION TIME
†NEW
PASSWORD
†TIME ZONE
POSITION LOCATION COMMANDS
†OPEN PORT *TXLIMIT †*POS †RED
†PASSWORDMO
DE
†POSRPT †RTCM
MODE CONTROL COMMANDS MASTER SIMULATOR COMMANDS
†CORPAT †*HALF DUPLEX *P
*FULL DUPLEX †*ROLE
MAINTENANCE COMMANDS
DUAL MASTER STATION COMMANDS
BOOT SHOW TXQ †SWCTL SWMON
RESET SMS
REV UPDT
UTILITY COMMANDS
SHOW RXQ FLASH HELP
WARNING/WEATHER SYSTEM
COMMANDS
DATA LOGGER COMMANDS
†FLOOD
TIMEOUT
†SENSOR P77 SDATA