Instruction Manual

9
Attachment Hub
Never put your hand into the feed chute when using any mixer attachment.
The mixer must be OFF before installing attachments! Do NOT use attachments while mixing!
1. Loosen and remove the attachment hub thumbscrew
2. Remove the cover from the attachment hub
3. Lubricate the attachment shaft with a food quality grease or
mineral oil
4. Insert the attachment shaft into the hub making sure to line
up the alignment pin with the hub hole.
5. Tighten the thumbscrew back into the hub and securely tighten it.
6. Select the appropriate speed setting by lifting or lowering the speed control lever.
NOTE: Make sure the bowl is up and the bowl guard is closed otherwise the mixer will not start.
7. Press the start button located on the middle of the control panel.
8. Always stop the mixer before changing speeds. Failure to do so may damage the gears or other
parts and will void the warranty.
9. To change the speed while using the mixer attachments, first press the stop button, then change
the speed using the gear control lever. Then press the start button to restart the machine.
The below table shows the recommended speeds while using the hub attachments:
Recommended Speed
1
st
Gear 2
nd
Gear 3
rd
Gear
Slicing
Grating
Mincing
Thumbscrew
Cover