Metcalfe MP20 20 Litre Heavy Duty Bench Mounted Mixer Installation & Operating Instructions t 01766 830 456 e sales@metcalfecatering.com w www.metcalfecatering.
Index Your Mixer .................................................................................................... 2 Technical Data ……………………..…………………..................................................... 3 Installation - Unpacking ........................................................................................ 4 - Location ...........................................................................................
Your Mixer Gear Selector Control Panel Attachment Hub Bowl Lift Handle Bowl Guard Bowl Rubber Feet 2
Metcalfe MP20 (20 Litre Heavy Duty Mixer) The Metcalfe MP20 has a total bowl capacity of 20 Litres. The three mixing tools provided ensure that all mixing requirements are met.
Installation Unpacking Unpack the mixer immediately after receipt. Please inspect the mixer to ensure no damage and all parts i.e. Bowl, Beater, Whisk & Dough Hook have been provided. If the machine is found to be damaged, keep all the packaging material and contact us immediately or contact your source of the equipment. Never attempt to operate the machine with damaged parts. Report any deficiencies to the dealer that supplied the machine.
Electrical Connection • • • • • • Before connecting the mixer to an electrical supply, please read the specifications on the rating plate to ensure that they comply with those of the electrical supply. Electrical connection should be made by a qualified service technician who will observe all applicable safety codes. The machine works off 220/240V 50Hz 1 phase supply and comes fitted with a 3-pin 13amp fused plug. An electrical supply should be available within the reach of the included power cord.
Operation Fitting the Bowl NOTE: Install the bowl BEFORE attaching the agitator. 1. Lower the bowl lift handle anti-clockwise and down to its resting position. 2. Lift the bowl by the handles and slowly position the locking pin located at the rear of the bowl into the hole in the middle rear of the cradle. (Figure A) 3. Lower the bowl onto the pins located on either side of the bowl cradle. 4. Once the bowl is in position, secure it by pulling each bowl clamp forward until the bowl is locked tight.
Fitting Attachments NOTE: Install the bowl BEFORE attaching the mixing tool. NOTE: It is easier to install the attachment prior to adding ingredients into the bowl. Open the bowl guard and lower the bowl. Slide the attachment slowly upwards onto the planetary shaft, fitting the shaft pin through the slot in the attachment. (Figure A) Rotate the attachment clockwise to secure it onto the planetary shaft. NOTE: Attachments should always rotate in a clockwise direction around the bowl.
Recommended Mixing Capacities PRODUCT MP20 Bowl size 20 litre Egg Whites 1 ltr Mashed Potatoes 6.8 kg Mayonnaise (Qts. Oil) 9.5 ltr Waffle/Pancake Batter 7.6 ltr Whipped Cream 3.8 ltr Fondant Icing 5.4 kg Cup / Layer Cake 9.5 kg Pound Cake 9 kg Sponge Cake 5.4 kg Pie Dough 8 kg Bread or Roll Dough (Light/Med, 60% AR) 11.3 kg Bread or Roll Dough (Heavy, 55% AR) 6.8 kg Thin Pizza Dough, Pasta, Basic Egg Noodle 4 kg (40% AR) 5 min max mix time Medium Pizza Dough (50% AR) 4.
Attachment Hub Never put your hand into the feed chute when using any mixer attachment. The mixer must be OFF before installing attachments! Do NOT use attachments while mixing! 1. Loosen and remove the attachment hub thumbscrew 2. Remove the cover from the attachment hub 3. Lubricate the attachment shaft with a food quality grease or mineral oil 4. Insert the attachment shaft into the hub making sure to line up the alignment pin with the hub hole. 5.
Cleaning Instructions ALWAYS disconnect from the power source when cleaning or servicing this machine. ALWAYS remove the attachment/s after each batch. If not, the attachment/s can become stuck on the shaft and difficult to remove. NEVER attempt to clean this machine while it is in motion, serious injury could result. NEVER use a scrubber pad, steel wool, or abrasive material to clean the mixer. NEVER use bleach or bleach based cleaner.
Troubleshooting Problem Mixer will not turn Mixing stops during mixing Mixer is noisy Possible Causes Bowl guard not in closed position Bowl not raised Action Required Rotate guard to the right until fully closed. Power not connected correctly Check all power connections. Plug into a live socket (do not use extension cord!). Test socket with another item. Raise bowl to highest position. Building circuit breaker is off Check breaker box Wait two minutes. Press stop button then press start button.
Problem Possible Causes Residue leaking from hub Contaminated hub due to food build-up Attachments touching bottom or sides of bowl Defective or dented bowl Remove dents or replace bowl Defective attachment Replace attachment Batch size too large for mixer Items too firm Speed too high Hand utensil dropped into bowl while mixing Reduce batch size (see Capacity Chart) Adjust recipe Reduce speed Broken whisk wires Broken beater Action Required Technician to remove hub and clean interior.
Spare Parts and Service For more information on Metcalfe spare parts, accessories and service support, including breakdown drawings and parts lists please contact us on the details below. Please always quote the Serial Number of the machine. This can be found on the serial number plate which is located on the rear of the machine. Metcalfe Sales & Spares Department sales@metcalfecatering.com Metcalfe Service Department service@metcalfecatering.com Metcalfe Website www.metcalfecatering.
Metcalfe Warranty All Metcalfe products are guaranteed against defects in material and workmanship for a period of one year from date of Invoice, except where specially noted. The Company's obligation under this warranty is limited to repairing or replacing, without charge, any part or parts found to be defective under normal use, in accordance with the specified operations manual and capacity ratings.
NS Slicer Range Peeler Range Ceado Roband 8/2021 Metcalfe Catering Equipment Ltd Haygarth Park Blaenau Ffestiniog Gwynedd, LL41 3PF t 01766 830 456 e sales@metcalfecatering.com 15 w www.metcalfecatering.
