Datasheet

- 2 -
INTRODUCTION
The MX-DS1 is a hand-held desoldering tool which utilizes shop air to create a powerful
Venturi vacuum to clean through-holes quickly and efficiently. Paper solder collection
liners within the hand-piece barrel are easy to maintain and are an improvement upon
traditional glass tubes. Shop air is required for operation.
ACCESSORIES & SPARES
MX-DCF1 DS1 Filter Pack; 15 Chamber Liners, 6 Fume Filters
MX-DCF1L DS1 Chamber Liners (pack of 40)
MX-MCF1F DS1 Fume Filters (pack of 20)
MX-DAR1 Air Regulator and Filter with Fittings
AC-TC-P Desolder tip Cleaner (Pack of 12)
AC-CB1-P Desolder Chamber Cleaning Brush (Pack of 25)
AC-CB2-P Desolder Tube Cleaning Brush (Pack of 6)
MX-DVC-1 Venturi Cartridge for Desolder Gun
MX-DSL1 DS1 Chamber Seal
MX-DSL2 DS1 Cartridge Seal
MX-DSB Desolder Gun Swivel Bushing
MX-DLA Desolder Gun Latch Adjustment (Pack of 10)
MX-DMK1 DS1 Maintenance Kit
CHOOSING THE CORRECT
GEOMETRY
Select a tip with an inside diameter
larger than the lead diameter. Select
a tip with an outside diameter that is
approximately the same size as the
pad.
A standard STDC cartridge can
desolder a maximum lead length of
0.0170." For fast, safe removal of devices that are difficult to reach on densely populated
boards, or to remove long pin connectors, try the STDC long reach cartridges. They are
identical to standard STDC tip cartridges, but with a 0.46" long extension at the tip.
CHOOSING THE CORRECT TEMPERATURE (SERIES)
Start with a 700 Series cartridge, switching to
a 800 Series only where absolutely
necessar
y; for example, when working with
ground planes or multi-layer boards. For long
reach tips, start with a 700 Series cartridge.
For extremely heavy loads tied to ground
planes, or very thick multi-layer boards, 800
Series cartridges may be necessary.
Inside Outside Part Number
Dia. Dia. 700 800 long reach long reach
(A) (B) Series Series 700 series 800 series
0.025" 0.055" STDC-102 STDC-802 N/A N/A
0.030" 0.066" STDC-103 STDC-803 STDC-703L STDC-803L
0.040" 0.070" STDC-104 STDC-804 STDC-704L STDC-804L
0.050" 0.080" STDC-105 STDC-805 STDC-705L STDC-805L
0.060" 0.090" STDC-106 STDC-806 N/A N/A
0.095" 0.125" STDC-107 STDC-807 N/A N/A
Correct
Too Small Too Large