Operation Manual

Revision 2.1
December 2, 2012 Page 1 of 13
Product information for model SW12 Bluetooth
Smartwatch
FCC Statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired
operation.
Changes or modifications not expressly approved by party
responsible for compliance could void the user’s authority to
operate the equipment.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to correct the interference by one of the
following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and
receiver.
 Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
 Consult the dealer or an experienced radio/TV
technician for help.
This portable transmitter with its antenna complies with the
FCC/IC RF exposure limits for general
population/uncontrolled exposure.
Industry Canada Statement
Under Industry Canada regulations, this radio transmitter
may only operate using an antenna of a type and maximum
(or lesser) gain approved for the transmitter by Industry
Canada. To reduce potential radio interference to other
users, the antenna type an d its gain should be so chosen
that the equivalent isotropically radiated power (E.I.R.P.) is
not more than that necessary for successful communication.
This Device complies with Industry Canada License exempt
RSS standard(s). Operation is subject to the following two
conditions:
1. This device may not cause interference.
2. This device must accept any interference, including
interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes:
1. L’appareil ne doit pas produire de brouillage.
2. L’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
CE Declaration of Conformity for SW12
We, Meta Watch, Ltd. Of Tekniikantie 14, 02150 Espoo
Finland declare under our sole responsibility that our
product
Meta Watch model SW12
and in combination with our accessories, to which this
declaration relates is in conformity with the appropriate
standards EN300 328: V1.7.1, EN301 489-17:V2.1.1 , and
EN60 950-1:2006 following the provision of, Radio
Equipment and Telecommunication Terminal Equipment
directive 1999/5/EC.
Espoo, Finland, 17 September 2012
______________________
Bill Geiser,
CEO
We fulfill the requirements of the R&TTE directive
(1999/5/EC)
Bluetooth® Statement
This product contains QDID BO 19335 and QDID BO 17137.
The Bluetooth® word mark and logos are registered
trademarks owned by Bluetooth SIG, Inc. and any use of
such marks by Meta Watch, Ltd. under license. Other
trademarks and trade names are those of their respective
owners.