User`s guide

4-32 Display Terminals
Setting the Clock
To set the clock:
1. Select the Time/Date option in the Main menu. The Time/Date
screen appears and the Time parameter is highlighted, as shown in
Figure 4-21.
dxtk_30
ALARM: Total:
FLOOR 8 AHU TIME/DATE 11:40
Date: March 24, 2000
Daylight Saving Date: Start: March 30
End: Oct 26
Time: 11:40
Figure 4-21: Time/Date Screen
2. Use the
and keys to move the highlight bar to the parameter
you want to change.
3. Press the
key to begin the edit sequence for the selected
parameter. The first value of the parameter begins to flash to
indicate that it can be changed. For example, if you selected the
Time parameter, the hours begin to flash.
4. Use the
or key to increase or decrease the selected value.
5. Press
again to confirm the new value. The next value of the
parameter begins to flash to indicate that it can be changed
(e.g., the minutes in the example).
6. Repeat Steps 4 and 5 for each value of the parameter until you
have edited all values of the parameter. The last press of the
key completes the edit sequence for the parameter and the new
values are sent to the DX controller.
Note: Press the
esc
key at any time to abort the edit sequence.
7. Repeat Steps 2 to 6 for the next parameter you want to change, or
press the
esc
key to return to the Main menu.