User`s guide

4-26 Display Terminals
dxtk_25
FLOOR 8 AHU POINT DATA 1/8 11:40
HA Room Temperature 25.8 Deg C
24.0 Deg C
Supply Air Temp 17.5 Deg C
OVR Supply Fan On
Return Fan On
Mixing Dampers 10.0 %
Heating Coil 0.0 %
Cooling Coil 75.0 %
Supply Filter Clean
Outside Air Temp 29.7 Deg C
Electric Meter 1234567 KWattH
ALM Humidifier S/S Fault
Room Set Point
ALARM: Room Temperature HA Total:02
Figure 4-16: Highlighted Point (Its Value Can Be Changed)
3. Use the
and keys to move the highlight up or down to select
the point you want to change. The highlight moves only to points
that can be commanded.
4. Press the
key to confirm your selection. The highlight moves
from the point’s description to its value, as shown in Figure 4-17.
The value begins to flash to indicate that it can be changed.
Note: If the selected point is already overridden (i.e., the OVR
status is shown to the left of the point description), then the
highlight first moves to the status when you press
to
confirm the selection. Press
again to reconfirm the OVR
status, and the highlight then moves from the status to the
point’s value.