User`s guide

4-18 Display Terminals
If a controller’s configuration does not match one of the predefined
configurations in the display unit, the default configuration is used
(if enabled) for that controller.
To choose and connect to a DX via the N2 Bus:
1. Use the
and keys to choose the desired controller.
2. Press the
key to confirm your selection. The Home Page for the
selected controller appears.
Note: You can display the diagnostic screen at any time during
normal operation by pressing the
esc
key twice in quick
succession, similar to double clicking a computer mouse
button.
Download/Upload Screen
If the DX LCD Display cannot communicate with a DX controller
when it is supplied with power, then it displays the Upload/Download
screen as shown in Figure 4-9.
dxtk_17
Dx91x0 NOT FOUND
READY FOR UPLOAD/DOWNLOAD
PRESS ANY KEY TO RESET
Figure 4-9: Upload/Download Screen
If this screen appears and a DX controller is connected to the display,
check the connections and reset the display by pressing any key.
For more information regarding the download procedure, refer to the
GX-9100 Software Configuration Tool Technical Bulletin
(LIT-6364060).