User`s guide

Operating the DX LCD Display 4-15
Procedure Overview
Table 4-4: Operating the DX LCD Display
To Do This Follow These Steps:
Establish Communication with
a DX Controller
Connect the serial cable between the display and the controller. Connect
the cord of the power supply adapter to the display and plug the adapter
into an AC wall socket.
For direct connect, when the power-on self-test is complete, press
to
continue.
Connect to a DX Controller via
the N2 Bus
Choose the controller from the Choose Controller screen, using
or
.
Press to confirm your selection.
If the DX LCD Display cannot communicate with a DX controller, the
Download/Upload screen appears. If necessary, follow download
procedures described in GX-9100 Software Configuration Technical
Bulletin (LIT-6364060).
Display the Main Menu
Press
esc
one or more times from any screen to return to the Main menu.
Select menu options in the Main menu to access all functions of the
display.
Display the Home Page
Select Home Page in the Main menu.
Enter a Password
Select Password in the Main menu, and use
,
and to enter
digits.
View Point Data
Select Point Data in the Main menu, and use
and to page through
data.
Adjust/Override Points
Select point in the Point Data, and use
,
and to change value.
Release Overridden Points
Select point in the Point Data, and use
,
and to change status to
REL.
View Alarm Summary
Select Alarm Summary in the Main menu, and use
and to page
through data.
View Alarm Log
Select Alarm Log in the Main menu, and use
and to page through
data.
Set the Clock
Select Time/Date in the Main menu, and use
,
and to change
values.
Edit Time Schedules
Select Time Schedules in the Main menu, and use
,
and to
change values.
Define Holidays
Select Holidays in the Main menu, and use
,
and to change
values.
Change Optimal Start/Stop
Parameters
Select Optimal Start/Stop in the Main menu, and use
,
and to
change values.
View Trend Data
Select Trend Data in the Main menu, and select the trend variable in the
Trend Data menu. For Analog Trend, Use
,
and to change plot
parameters. For Digital Trend, Select the trend bit in the Trend Group
menu, and use
and to page through data.
Connect to Another Controller
(N2 Bus Operation Only)
Select Choose Controller from the Main menu. Use
and
to select
the corresponding controller listed, then press
to confirm the selection.