User`s guide

Installing the DX LCD Display 3-9
Mounting the DX LCD Display on a UPM
To mount the DX LCD Display on a UPM:
1. Position the wall mounting bracket on the UPM to allow
mounting of the DX LCD Display (Figure 3-6).
2. Mark four mounting holes.
3. Mark a cable hole.
4. Drill four pilot holes for mounting the base (hole size should be
between 0.160 inch and 0.170 inch, bit size No. 18, 19, or 20).
5. Drill a 1/2 inch hole for communication and power cables.
Four Holes at
4.3 mm (0.17 in) Diameter
upmfront
Washer
20 mm
(0.79 in)
76 mm
(3.00 in)
Figure 3-6: Mounting the Wall Mounting Bracket on a UPM
6. Position the two washers provided in the Wall Mounting Kit over
the two holes on the right side of the UPM. The washers must be
on the outside of the UPM. These washers compensate for the
indentation on the right side of the UPM.
7. Secure the mounting bracket to the UPM cover using the
four bolts and nuts included with the Wall Mounting Kit.
8. Detach the flap covering the connectors from the DX LCD
Display. This allows cables to be routed through cable hole.
9. Connect the serial cable and power connector to the display.
10. Connect the serial cable from the display to the DX controller
place the display unit onto the bracket.