User`s guide

3-8 Display Terminals

4. Place the DX LCD Display on the bracket, as indicated by  in

Figure 3-5.

Note: The springs of the bracket fit into the rounded cavities in the

back of the display. Align the slots in the bracket and the

slots in the sides of the display unit.

Dxtk_7

Figure 3-5: Securing the DX LCD Display to the Wall

5. Secure the DX LCD Display to the bracket by inserting the

locking tabs supplied with the wall mounting kit into the

corresponding slots at the sides of the DX LCD Display, as

indicated by  and  in Figure 3-5.

Note: Apply a slight pressure on the front of the display against the

springs of the bracket while inserting the tabs. Make sure to

push the tabs all the way in so that they pass through the

bracket and re-enter the second slot in the back of the display

unit.

6. Connect the serial cable from the display to the DX controller.

Refer to the Cabling a Permanently Mounted Device section in

this chapter.