User`s guide

3-6 Display Terminals
To Do This (Cont.) Follow These Steps:
Cable a Permanently Mounted
Device (Cont.)
To establish the N2 Bus connection:
Plug the connector on one end of the serial communications cable into the
DX LCD Display.
Plug the other end of the serial communications cable into the 9-pin
adapter marked IU for the IU-9100 in Europe, or into the 25-pin adapter
marked CVT for the MM-CVT101 in North America.
Plug the adapter into the RS-232 serial port socket of the IU-9100 or
MM-CVT101 RS-232/RS-485 converter.
Cable a Portable Device
Plug one end of the serial communications cable into the DX LCD Display
and the other end into the adapter marked DX/PC.
Plug the adapter into the DX controller.
Plug the power supply adapter into the DX LCD Display and into wall
socket.