User`s manual

Rev. 1.00
- 21 -
Metapace T-1
5. Appendix
5-1 Cleaning Printer
Paper dust inside the printer may lower the print quality. In this case clean the printer as
follows.
5-1-1 Open the printer cover and remove any existing paper.
5-1-2 Clean the print head with a cotton swab moistened with alcohol solvent.
5-1-3 Clean the platen roller and paper end sensor with cotton swab moistened with water.
5-1-4 Insert a paper roll and close the printer cover.
The remaining amount of paper detected by the paper near end sensor varies with the
diameter of the paper core.
Contact your dealer to adjust the remaining amount.
5-2 Printing speed
When the paper is about to run out, the printing speed may become slower while printing.
Press the Push button and then open and close the cover to print at normal speed until all
the paper is used.