User`s manual

Rev. 1.00
- 16 -
Metapace T-1
1-6 Adjustments and Settings
The Metapace T-1 is set up at the factory to be suitable for almost all users. It does,
however, offer some settings for users with special requirements.
It has DIP switches that allow you to change communication settings, such as
handshaking and parity check, as well as print density.
The Metapace T-1 also has a near-end sensor for the paper. This can give you a warning
when the paper is almost used up. If you find that there is not enough paper remaining on
the roll when the near-end sensor is triggered, you can change the near-end sensor
setting. Rotate the near end sensor tab to the front or rear position. (See the figure below)
1-7 Using the Printer
Control Panel
○ POWER
When turning on the power, a green LED will light up.
○ ERROR
When an error occurs, a red LED will light up.
(e.g. no paper, cover ajar, etc.)
○ PAPER
A red LED will light up when the paper roll is running low. The LED
blinks when the printer is in self-test standby mode or macro execution
standby mode.
○ FEED
Press the FEED button once to discharge extra paper. Holding down the
FEED button will discharge paper continuously until the button is
released.
Near end sensor tab