User`s manual

Rev. 1.00
- 13 -
Metapace T-1
1-4-2 Parallel & USB Interface
SW Function ON OFF Default
1 Auto Line Feed Always Enabled Always Disabled OFF
2 Reserved - - OFF
3 Reserved - - OFF
4 Reserved - - OFF
5 Reserved - - OFF
6 Reserved - - OFF
7 Reserved - - ON
8 Reserved - - OFF
DIP switch Setting 1 Function
SW Function ON OFF Default
1 Emulation STAR EPSON OFF
2 Internal Bell Control
Internal Bell
Disabled
Internal Bell Enabled OFF
3 Auto Cutter Selection Disabled Enabled OFF
4 Busy Condition Input Buffer Full
• Offline
• Receive Buffer Full
OFF
5 OFF
6
Select Print Density Refer to the Following Table
OFF
7 Near End Sensor Status Disabled Enabled OFF
8 Reserved - - OFF
DIP Switch Setting 2 Function
Print Density SW - 5 SW – 6
1 ( Light ) ON ON
2 OFF OFF
3 ON OFF
4 ( Dark ) OFF ON
Select Print Density