User manual

26
Enter Setup
Metapace S-2 Hardware Manual
from low to high upon the resumption. If the scanner fails to resume the connection, it will
try every 5 seconds to re-connect to the host unless you have the scanner read the “Reset
Connection” barcode.
 For BT SPP Slave Mode, the scanner waits for the host to re-connect.
 For BT SPP Master Mode, the scanner resumes the connection with the host upon
powering on again as long as the host application is running. You will hear three short
beeps, tone ascending from low to high upon resumption. If the scanner fails to resume
the connection, it will try every 5 seconds to re-connect to the host unless you have the
scanner read the “Reset Connection” or “Restore System Defaults” barcode.
 With the use of the cradle, the scanner tries to re-connect to the cradle unless you turn off
the scanner.