Installation Guide

3
EATON IB519034EN Installation instructions
Installation Instructions – Cruze LED Retrofit Kit
7. If needed, use pocket lance to help align locating tabs
with Main Panel. (Use Flathead screwdriver if needed)
8. Secure Main Panel by turning each fastener 90 degrees.
9. Connect quick disconnect from driver to main supply
wire.
10. Grounding - If host fixture ground connection is made
through host luminaire, screw ground wire from
Retrofit Kit Main Panel to existing luminaire housing. If
not, connect ground wire to incoming ground wire.
11. Install Side Panel (B) between luminaire housing and
T-grid. Make sure the tabs at each corner of the Main
Panel slide into each slot on the End Plates.
12. Secure Side Panel (B) by turning each fastener 90
degrees. Then remove LED protective cover from LED
board
B
B
Locating Tabs