Product Manual

Page 8 of 28
STYLE 26 TIG TORCH
The TIG torch transfers welding power from the welding power source to the tungsten for the purpose of TIG welding. It
also delivers the shielding gas from the welding power source to the welding zone. This style 26 torch uses the same
common parts as other Style 26 TIG torches
GROUND CABLE AND CLAMP
The ground cable and clamp are attached to the work piece to complete the circuit allowing the flow of current needed to
weld.
REGULATOR/FLOWGAUGE AND GAS HOSE
The regulator installs directly on the shielding gas cylinder. Required for TIG welding. The regulator controls the
compressed gas and allows you to adjust the flow rate of the gas. The gas hose connects to the regulator/flow gauge and
delivers the shielding gas from the shielding gas bottle to the welder.
ELECTRODE HOLDER AND CABLE
The electrode holder and weld cable transfers welding power from the welding power source to the electrode for the
purpose of stick welding.
WELD PROCESS INDICATORS
When the push button below this set of indicator lights is pushed, the operator can sequence through the different welding
processes.
INDICATOR LIGHTS
The indicator lights can be used to help with troubleshooting the welder. When the power indicator light is on, input power
is supplied to the main transformer and control circuit. When the work indicator is on, it is indicating welding current is
activated. When the temperature indicator is on, the machine has gone into protection mode and requires the internal
temperature to cool. When the power protection light is on, the machine has gone into protection mode and requires that
the input voltage stabilize to within 15% of the rated input voltage.