Product Manual

Page 7 of 28
TECHNICAL SPECIFICATIONS
Item
Specification
Power Supply
120V, 20A, 50/60 Hz, Single Phase
230V, 22A, 50/60 Hz, Single Phase
No-Load Voltage
60V DC
Output Range - STICK
10 to 80A DC with 120V Input Power
10 to 160A DC with 230V Input Power
Output Range – TIG DC
10 to 120A with 120V Input Power
10 to 200A with 230V Input Power
Output Range – TIG AC
15 to 120A with 120V Input Power
15 to 200A with 230V Input Power
Duty Cycle - STICK
35% @ 80A with 120V Input Power
20% @ 160A with 230V Input Power
Duty Cycle- TIG AC/DC
35% @ 120A with 120V Input Power
20% @ 200A with 230V Input Power
Pulse Frequency
0.2Hz to 500Hz
AC Arc Frequency
50 Hz to 150Hz
AC Arc Balance Control
50% to 85% EN
Weight
31.97 lb.
Dimensions
19.69 in X 9.45 in X 16.14 in
DESCRIPTION
The Metal Man Inverter Powered MMTIG201IDV is a dual voltage, inverter powered AC and DC TIG, Pulse TIG and
DC Stick welder. This unit is intended to be used on a 50-amp 230V AC circuit or 120V, 20A AC Circuit, without the
use of an extension cord. This machine comes complete with a TIG Torch, a Foot Pedal, regulator/flowmeter with inert
gas hose, a ground cable and clamp, and an Electrode Holder with cable.
The MMTIG201IDV is the ideal Stick and TIG welder for every shop. The DC stick mode allows you to stick weld
when your application requires it. In the DC TIG mode, you can TIG weld metals such as steel and stainless steel. In
the AC TIG mode, you can TIG weld non-ferrous metals such as Aluminum. This unit is equipped with advanced TIG
capabilities including Pulse, AC Arc Frequency Control, AC Arc Balance Control, and Auto Balance/Frequency
Control. The advanced inverter technology that powers the Metal Man MMTIG201IDV provides for better arc control,
lower power consumption, in a lighter more portable unit.
DIGITAL METERS
Digital meters display welding amperage and voltage while welding.
FUNCTIONAL CONTROL
Use the Functional Control dial to increase and decrease the value of the function you are setting. An indicator light
will then illuminate showing which function you are setting.
WELD PARAMETER SETTING INDICATORS
When the push button below this set of indicators lights is pushed, the operator can sequence through the different
welding parameters. Use the Functional control to adjust the parameter setting indicated on the digital meters.
REMOTE FOOT PEDAL CONTROL
The foot pedal is used to start the arc and manually adjust the amperage while TIG welding. The cord will attach to
the 5-Pin connector on the front of the unit.