Product Manual

Page 12 of 29
Gas selection:
Except for very specialized TIG welding applications, TIG welding can be done with 100% Argon.
Consult your gas supplier for more information.
8. REMOTE CONTROL INSTALLATION
NOTE: When stick welding, remove all remote controls. Failure to do this will result in minimal welding
output only.
Remote Contactor and Amperage Control – This unit comes standard with a remote foot pedal control.
The remote foot pedal is used to initiate the arc and then vary the amperage during your weld. Connect
the remote foot pedal control to the Foot Pedal Connection on the front of the unit.
Remote
Foot Pedal
Connection
EQUIPMENT SET-UP
Electrical Shock Can Kill!
• High voltage danger from power source! Consult a qualified electrician for proper
installation of receptacle. This welder must be grounded while in use to protect the
operator from electrical shock.
• Do not remove grounding prong or alter the plug in any way. Use only the supplied
adapter between the welder's power cord and the power source receptacle. Make sure
the POWER switch is OFF then connect your welder's power cord to a properly
grounded 230 VAC (220V
- 240V), 60 HZ, single phase, 50-amp power source. If operating on 120V, attach the
120V Adapter cord to the unit power cord and then connect the assembly to a properly
grounded 120 VAC (110V-130V), 60 Hz, single phase, 20-amp power source.
1. PROCESS SELECTION