Manual

Operating Instructions – MOVIMOT® MM03C - MM3XC

Diagnostics of MOVIMOT® standard design

Diagnostics

Diagnostics via

MDG11A option

• The diagnostic unit cannot be used in conjunction with MOVIMOT

with integrated

AS-Interface.

• The diagnostic unit must be connected prior to the possible occurrence of a fault, as

MOVIMOT

error messages are not saved and the information is lost when the 24 V

supply is disconnected.

• The diagnostic unit may only be connected to a MOVIMOT

unit.

• Connecting the MDG11A to an RS-485 bus with several MOVIMOT

is not allowed.

• The diagnostic unit can be used only if the MOVIMOT

is controlled via terminals.

This requires that DIP switches S1/1 to S1/4 are set to OFF (= address 0).

• Do nut use the diagnostic unit in case setpoint setting takes place via the

RS-485 interface.

• Connection according to section "Electrical Installation."

05240AXX

03125AXX

543

432