Instruction manual

Instruction Manual

Mobile thermal drilling

5.4. Inserting the collet

1. Insert the collet at a slight angle into the screwed cap and turn both using light pressure in

opposite directions until the collet perceptibly locks and sits vertically in the screwed cap. The

collet should no longer fall out on its own.

Nut der Spannzange = Groove of collet, Exzenterring = Eccentric ring, Markierung = Marking

2. Now screw both together onto the drill chuck such that the tool shaft can then be inserted with

slight suction.

5.5. Inserting the FLOWDRILL

tools

The Flowdrill or Flowtap is inserted with the tool holder already mounted and the screwed cap

including collet lightly tightened. All tools must be inserted fully as far as the stop. Then hand tighten

the screwed cap. To fully tighten the tools please use the enclosed spanners (spanner SW19 / open-

ended spanner SW25).

5.6. Mains connection

Connect the mains plug to the mains supply. If you are using an extension cable, ensure that it is

designed for the rating of the machine.