STEB 70 Quick STEB 80 Quick en Original instructions 9 www.metabo.
15 16 17 14 13 12 11 10 30 mm 9 8 7 6 5 4 3 2 1 2
STEB 70 Quick STEB 80 Quick Nm (inlbs) 6 (53.1) 6 (53.1) T1 mm (in) 70 (2 3/ 80 (3 5/32) T2 mm (in) 20 (25/32) 25 (1) T3 mm (in) 6 (1/4) 8 (5/16) n0 min-1 (rpm) 3300 3300 P1 W 570 590 P2 W 335 350 m kg (lbs) 2,0 (4.4) 2,0 (4.4) ah,CM/Kh,CM m/s2 8,5 / 2 8,5 / 2 ah,CW/Kh,CW m/s2 12 / 2 12 / 2 LpA/KpA dB(A) 89 / 3 89 / 3 LWA/KWA dB(A) 100 / 3 100 / 3 13.
A 6.
ENGLISH en Original instructions 1. Conformity Declaration We, being solely responsible, hereby declare that these jigsaws conform to the standards and directives specified on page 3. 2. Specified Use The machine is suitable for sawing non-ferrous metals and sheet steel, wood and similar materials, plastics and similar materials. Any other use is not permitted. The user bears sole responsibility for damage caused by improper use.
en ENGLISH 6. Commissioning Before plugging in, check to see that the rated mains voltage and mains frequency, as stated on the rating label, match your power supply. Never operate the machine without a saw blade. 6.1 Fitting the anti-splintering footplate insert Danger of injury due to the sharp jigsaw blade. Remove the saw blade before fitting (8) the antisplintering footplate insert. Turn the machine over so that the footplate faces upwards.
ENGLISH en hands. Therefore always hold the machine with both hands using the handle provided, stand securely and concentrate. 8. Cleaning, Maintenance Clean the machine regularly. This includes vacuum cleaning the ventilation louvres on the motor. Clean the saw blade clamping fixture regularly and thoroughly by blowing with compressed air. If necessary, clean the openings behind the saw blade support roller (2). Apply a drop of oil to the saw blade support roller (2) from time to time. 9.
en ENGLISH Emission values These values make it possible to assess the emissions from the power tool and to compare different power tools. Depending on the operating conditions, the condition of the power tool or the accessories, the actual load may be higher or lower. For assessment purposes, please allow for breaks and periods when the load is lower. Based on the adjusted estimates, arrange protective measures for the user e.g. organisational measures.
Metabowerke GmbH, 72622 Nürtingen, Germany www.metabo.
