Use And Care Manual
7. About Remaining Battery Indicator
Remaining battery power can be verifi ed by pulling on
the switch to light up the remaining battery indicator
lamp. (Fig. 11)
The indicator lamp will turn off 10 seconds after the
switch is released.
The Table 6 shows the state of remaining battery
indicator lamp and the battery remaining power.
Table 6
State of lamp Battery Remaining Power
The battery remaining power is
enough.
The battery remaining power
is a half.
The battery remaining power is
nearly empty.
Re-charge the battery soonest
possible.
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
Display panel
Switch trigger
Remaining battery
indicator lamp
Fig. 11
NOTE
Do not give a strong shock to the display panel or
break it. It may lead to a trouble.
6. Using the hook (for models with attached hook)
The hook is used to hang up the power tool to your
waist belt while working.
CAUTION
●
When using the hook, hang up the power tool
fi rmly not to drop accidentally.
If the power tool is dropped, it may lead to an
accident.
●
When electing to carry the tool hooked to your
hip belt, make sure to detach the tool bit and side
handle.
Failure to do so may result in unexpected injury.
●
Install securely the hook. Unless the hook is
securely installed, it may cause an injury while
using.
(1) Removing the hook.
Remove the screws fi xing the hook with Philips screw
driver. (Fig. 9)
Hook
Screw
Groove
Fig. 9
(2) Replacing the hook and tightening the screws.
Install securely the hook in the groove of power
tool and tighten the screws to fi x the hook fi rmly.
(Fig. 10)
Screw
Hook
Groove
Fig. 10
13
English
0000WH18DBFL2metabo.indb130000WH18DBFL2metabo.indb13 2019/06/1117:00:002019/06/1117:00:00