Use And Care Manual
17
English
Push Lever
Trigger
3
4
WARNING
● A nail will fi re each time the trigger
is depressed as long as the push
lever remains depressed.
(2) Continuous operation (Push lever fi re)
Using CONTACT ACTUATION
MECHANISM
WARNING
● To avoid double fi ring or accidental
fi ring due to recoil.
1) Do not press the nailer against the
wood with excessive force.
2) Separate the nailer from the wood
as it recoils after nailing.
1 Set the switching device to the
downward position (to set to CONTACT
ACTUATION MECHANISM).
(Set the switching device to the
downward position completely as
shown in the diagram. Otherwise, it will
not operate properly.)
2 Pull the trigger with the Nailer off the
workpiece.
3 Depress the push lever against the
workpiece to drive a nail.
4 Move the Nailer along the workpiece
with a bouncing motion.
Each depression of the push lever will
drive a nail.
As soon as the desired number of nails
have been driven, remove fi nger from the
trigger.
Switching Device
1
Downward position
Previously pull the trigger
2
4
Push Lever
WARNING
● Keep your fi nger off the trigger
except during nailing operation,
because serious injury could
result if the push lever accidentally
contacts you or others in work area.
● Keep hands and body away from the
discharge area. This metabo HPT nailer
may bounce from the recoil of driving
a nail and unwanted subsequent nail
may be driven, possibly causing injury.
The SINGLE SEQUENTIAL ACTUATION
MECHANISM is for use where precision
fastener placement is desired.
The SINGLE SEQUENTIAL ACTUATION
MECHANISM may reduce the possibility of
bodily injury to you or others in the work area
compared to the CONTACT ACTUATION
MECHANISM. This is because it is less
likely to drive an unwanted nail if you keep
the trigger pulled and accidentally bump
the push lever against yourself or others.
000BookNT65MA4(S)USmetabo.indb17000BookNT65MA4(S)USmetabo.indb17 2018/02/0714:38:362018/02/0714:38:36