Use And Care Manual
16
English
4) handing it to another person;
5) changing switching device;
6) performing any maintenance or
repairs;
7) clearing a jam;
8) Nailer is outside of the operator’s
supervision or control;
9) removing nails from the
magazine;
10
) adjusting nailing depth;
11
) attaching or removing the nose
cap; and
12
) turning the top cover.
This metabo HPT nailer is equipped with a
nailer operation switching device.
Use SINGLE SEQUENTIAL ACTUATION
MECHANISM or CONTACT ACTUATION
MECHANISM in accordance with the work to
be performed.
Explanation of the various nailing operations
○ SINGLE SEQUENTIAL ACTUATION
MECHANISM: First, press the push lever
against the wood; next, pull the trigger to
drive the nail.
After nailing once, nailing will not be
possible again until the trigger is released
and pressed again.
○ CONTACT ACTUATION MECHANISM:
First, press the push lever against the
workpiece; next, pull the trigger to drive
the nail. Or,
pull the trigger; next, press the push lever
against the workpiece to drive the nail.
If the trigger is held back, a nail will be
driven each time the push lever is pressed
against the wood.
NOTE
If you wish to fi x the setting to the SINGLE
SEQUENTIAL ACTUATION MECHANISM,
the SINGLE SEQUENTIAL ACTUATION
MECHANISM KIT is also available as
order part number 887916.
METHODS OF OPERATION
This Nailer is equipped with the push lever
and does not operate unless the push lever is
depressed (upward position).
There are two methods of operation to drive
nails with this Nailer.
They are:
1. Intermittent operation (Trigger fi re):
2. Continuous operation (Push lever fi re):
(1) Intermittent operation (Trigger fi re)
Use the SINGLE SEQUENTIAL
ACTUATION MECHANISM setting.
WARNING
● For intermittent operation, set the
switching device to the upward
position completely. (i.e. Set to
SINGLE SEQUENTIAL ACTUATION
MECHANISM.)
● To avoid double fi ring or accidental
fi ring due to recoil.
1) Set the switching device
to SINGLE SEQUENTIAL
ACTUATION MECHANISM.
2) Pull the trigger rapidly and fi rmly.
1 Set the switching device to the
upward position (to set to SINGLE
SEQUENTIAL ACTUATION
MECHANISM).
(Set the switching device to the
upward position completely as shown
in the diagram. Otherwise, it will
be set to CONTACT ACTUATION
MECHANISM.)
2 Position the nail outlet on the workpiece
with fi nger off the trigger.
3 Depress the push lever fi rmly until it is
completely depressed.
4 Pull the trigger to drive a nail.
5 Remove fi nger from the trigger.
To continue nailing in a separate location,
move the nailer along the wood, repeating
steps 2 - 5 as required.
Switching Device
1 Upward position
000BookNT65MA4(S)USmetabo.indb16000BookNT65MA4(S)USmetabo.indb16 2018/02/0714:38:362018/02/0714:38:36