Use And Care Manual
24
English
<NT1850DE>
(1) Lightly press the stop lever and gently pull out the
magazine cover.
Pull out
Press
Stop lever
Magazine cover
(2) Set nail strip into the magazine and keep the points of
nails in contact with Groove.
Nails strip
Magazine
Groove
NOTE
●
The nails shown in page 15 - 16 can be loaded onto
the side guide groove of the magazine without any
adjustment.
Always keep the points of nails in contact with
Groove.
Magazine
Gap
Side guide
groove
Nail
Groove
(3) Slide the nail strip into the blade guide.
Nail strip
Blade guide
(4) Confi rm that nail strip is placed with side guide
grooves and Groove properly, then push the
magazine cover forward to be latched.
NAILER OPERATION
Read section titled “SAFETY” (pages 5 – 12).
DANGER
●
Operators and others in
work area MUST wear safety
glasses with side shields
which conforms to ANSI Z87.1
specifi cations.
WARNING
●
NEVER point tool at yourself
or others in work area.
●
Keep fi ngers AWAY from
trigger when not driving nails
to avoid accidental fi ring.
●
Do not use the electrical cord if damaged.
Have it repaired immediately.
●
Choice of triggering method is important.
Please read and understand “METHODS OF
OPERATION” found below.
●
Before starting work, check the nailing
operation switching device.
This metabo HPT nailer includes a nailing
operation switching device.
Before starting work, make sure that the
switching device is properly set.
If the switching device is not set properly, the
nailer will not operate correctly.
●
Never place your face, hands or feet near
fi ring head when using.
●
Do not drive nails on top of other nails or
with Nailer at too steep of an angle; nails can
ricochet and hurt someone.
000BookNT1865DMAmetabo.indb24000BookNT1865DMAmetabo.indb24 2018/03/1416:07:292018/03/1416:07:29