Use And Care Manual

22
English
(4) Remove any nails, adhesive, fragments, splinters or other foreign objects jammed in the guide groove of the push
lever or the blade guide.
Driver blade position How to remove jammed nails
[Blade guide side]
Blade Guide
Clogged
Nail
Driver Blade
(1) Bend the driver blade back with
the slotted screwdriver.
(2) Remove the nails with the pliers.
(3) Remove any nail fragments or dirt
that remains in the guide groove
with the slotted screwdriver.
Driver Blade
Nail
Pliers
Slotted
Screwdriver
Guide
Groove
[Push lever side]
Push Lever
Clogged
Nail
Driver Blade
(1) Remove the nails with the pliers.
(2) Remove any nail fragments or dirt
that remains in the guide groove
with the slotted screwdriver.
Guide
Groove
Pliers
Nail
(5) Attach the guide plate and nose.
Guide Plate
Bolt (×2)
Nose
Push Lever
Driver Blade
Magazine
Insert the projection of the guide plate into the guide
hole and secure it with the hexagon hole bolt M5×8.
(If the projection of the guide plate is hard to insert,
tap it lightly with the handle of the screwdriver.)
(6) After assembling, pull out the push lever and nose
and check that they move up and down smoothly.
* Do not place your hand in front of the
discharge outlet when checking operation
Guide Plate
Nose
Push Lever
If any jammed nails remain, movement will not be
smooth.
In this case, repeat from step (1) again.
CAUTION
● NEVER hit the driver blade.
● NEVER point the tool at yourself or another
person, to avoid risk of injury by mis-fi ring.
NOTE
In case of frequent jam, contact a metabo HPT
authorized service center.
000BookNP18DSALUSmetabo.indb22000BookNP18DSALUSmetabo.indb22 2018/09/2716:18:592018/09/2716:18:59