User Manual

English
— 16 —
2) the Stapler is always held firmly against
the workpiece.
If staples are driven too deep or shallow into
the workpiece, adjust the stapling in the
following order.
1 DISCONNECT AIR HOSE FROM
STAPLER.
2 To adjust the driven-in depth of a staple,
loosen the screw that secures a push
lever piece.
If the staple is driven in deeply, adjust
the push lever piece to ”down”, and if
it’s driven in shallowly, adjust the push
lever piece to “up”.
3 Tighten the screw to fasten the push lever
piece when a suitable position is reached
for a stapling test.
4 Connect the air hose.
ALWAYS WEAR EYE PROTECTOR.
Perform a stapling test.
Disconnect
air hose
14
Push lever
piece
Screw
5 DISCONNECT AIR HOSE FROM
STAPLER.
6 Choose a suitable position for the push
lever piece.
Too deep
Too shallow
01Eng_N5008AC2_US 3/4/09, 18:2716