Use And Care Manual

TROUBLESHOOTING GUIDE
WARNING
● To avoid injury from an accidental start, turn the switch OFF and remove the plug from the
power source or remove the battery from the main body before making any adjustments.
● All electrical or mechanical repairs should be done only by qualified service technicians.
Contact metabo HPT Authorized Service Center.
Problem Possible Cause Possible Solution
Tool will not start. Battery not installed properly. Check the battery installation.
Battery not charged. Charge battery using appropriate charger.
Battery overheated. Remove battery from tool and let battery
cool for while.
Battery will not charged. Battery pack not installed into Charger
properly.
Insert battery into charger until charge
status lamp (red) appears.
Charger not plugged in. Plug charger into a working receptacle.
Battery temperature too hot Remove battery from charger, cool battery.
For more detail, refer to “Charging
Method”.
Battery temperature too cold Remove battery from charger, move
battery and charger to a surrounding air
temperature of above 32°F (0°C)
For more detail, refer to “Changing
Method”.
18
English
DS18DGL.indb18DS18DGL.indb18 2018/10/0513:48:222018/10/0513:48:22