Use And Care Manual
THE SCOPE AND SUGGESTIONS FOR USES
Table 5
Work Clutch dial position Suggestions
Drilling
Wood
Use for drilling purpose.Steel
Aluminum
Screw
tightening
Machine
screw
1 – 22
Use the bit and socket matching the
screw diameter.
Wood
screw
1 –
Use after drilling a pilot hole.
HOW TO SELECT TIGHTENING TORQUE
Table 6
Clutch dial
position
Tightening torque Operation example
1 Approximately 9 in.-lbs. (10 kg-cm)
Machine screw
tightening Screw
tightening for soft wood
material
3 Approximately 15 in.-lbs. (17 kg-cm)
7 Approximately 23 in.-lbs. (26 kg-cm)
13 Approximately 35 in.-lbs. (40 kg-cm)
17 Approximately 43 in.-lbs. (49 kg-cm)
Screw tightening for hard wood material
22 Approximately 52 in.-lbs. (60 kg-cm)
High speed: approximately 106 in.-lbs (122 kg-cm)
Thick screw tightening
When used as a drill.
Low speed: approximately 400 in.-lbs. (459 kg-cm)
NOTE
The selected content shown in Table 4 indicates the
diff erences according to screw type, screw size and
material used.
CAUTION
●
While operating the Cordless driver drill, take
care not to lock the motor.
If the motor is locked, immediately turn the
power off .
If the motor is locked for a while, the motor or
battery will be burnt.
●
Do not tighten too strongly as the screw heads
will be damaged.
16
English
DS18DGL.indb16DS18DGL.indb16 2018/10/0513:48:212018/10/0513:48:21