Use And Care Manual

19
English
9. How to use the LED light
While the switch is pulled, the LED light will
automatically light up the tip portion of the tool.
(Fig. 35)
The LED light will automatically turn off 10 seconds
after the switch is released.
The LED light also functions as a warning signal that
lights up during use.
For details, see “10. LED light warning signals”.
Also, pressing the lighting switch on the switch panel
will power on the LED light. Pressing it once again will
extinguish the light.
Trigger switch
LED light
Fig. 35
NOTE
To prevent battery consumption when the LED light
is left on, the light will automatically power off if the
switch is untouched for approximately one hour.
CAUTION
● Do not expose directly your eye to the light by
looking into the light.
If your eye is continuously exposed to the light,
your eye will be hurt.
● Wipe off any dirt or grime attached to the lens of
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.
10. LED light warning signals (Fig. 36)
This product features functions that are designed
to protect the tool itself as well as the battery. While
the switch is pulled, if any of the safeguard functions
activate during operation, the LED light will blink as
described in Table 6. When any of the safeguard
functions are triggered, immediately remove your
fi nger from the switch and follow the instructions
described under corrective action.
Fig. 36
Table 6
Safeguard Function LED Light Display Corrective Action
Overburden Protection
On 0.1 second/off 0.1 second
Remove the cause of the overburdening.
Temperature Protection
On 0.5 second/off 0.5 second
Allow the tool and battery to thoroughly
cool.
11. About remaining battery indicator
You can check the battery’s remaining capacity by
pressing the remaining battery indicator switch to
light the indicator lamp. (Fig. 37, Table 7)
The indicator will shut off approximately 3 seconds
after the remaining battery indicator switch is
pressed.
It is best to use the remaining battery indicator as
a guide since there are slight diff erences such as
ambient temperature and the condition of the battery.
Also, the remaining battery indicator may vary from
those equipped to a tool or charger.
Display panel
Remaining battery
indicator lamp
Remaining battery
indicator switch
Fig. 37
000BookCR36DANA.indb19000BookCR36DANA.indb19 2018/04/2710:41:112018/04/2710:41:11