Use And Care Manual
CAUTION:
●
Always take care in preventing the power cord from coming near the revolving saw blade.
●
Before starting to saw, ensure that the saw blade has reached full speed revolution.
1. Place the saw body (base) on the work piece, and as in Fig. 13 align the
intended line of cut with the saw blade, using the notch. This relationship
of base to work pieces should remain unchanged regardless of the
inclination of the base.
2. The switch should be turned to the ON position before the saw blade
comes into contact with the work piece. The switch is turned ON when
the trigger is pulled by one’s fi nger, and is turned OFF when the trigger is
released.
3. Moving the saw straight at a constant speed will produce optimum cutting.
[POCKET CUTTING]
WARNING:
●
To avoid serious accident, ensure the switch is OFF position,
and disconnect the plug from the receptacle before any
adjustment.
●
Never tie or wedge the lower guard in a raised position.
1. Mark the desired cutting area clearly with lines all side. (See
Fig. 14)
2. Set depth adjustment according to material to be cut.
3. Push the lever all the way back so the blade is exposed as shown
in Fig. 14.
4. Tilt saw forward and align the notch (Fig. 13) with the pre-marked
guide line.
5. Release the lever. When the lower guard contacts the work piece
surface, it will be in proper position to open freely when cutting is commenced.
6. Holding the saw in position, with the blade not contacting the work piece surface, pull the trigger.
7. After the saw has reached full speed, gradually lower rear end of the saw until its base rests on the work surface.
8. Advance saw along the cutting line up to the corner.
9. Release trigger and allow blade to stop completely before withdrawing the blade from the work piece.
○
Never under any circumstances pull the saw backwards while the blade is in motion, as kickback may result.
10. Use a jig saw or hand saw to cut the corners out clean.
11. When starting each new cut, repeat as above.
Fig. 13
When not
Inclined
When
Inclined 45°
Fig. 14
Lever
14
English
00BookC7URNAmetabo.indb1400BookC7URNAmetabo.indb14 2018/03/2217:50:352018/03/2217:50:35