Use And Care Manual

6. How to use the LED light
By pressing the light selector switch on the switch
panel, the LED light mode changes as Table 6. It is
indicated by green lamp. (Fig. 26)
To prevent the battery power consumption, turn off the
LED light frequently.
Lighting mode indicator lamp
Switch panel
Light section
switch
LED Light
Fig. 26
Table 6
Always-ON
mode
SW
interlocked
mode
Always-OFF
mode
Panel
display
State
Always ON
(turn off after
2 minutes)
Light only
SW-ON
(Automatically
goes out
approximately
10 seconds
after the
switch is
released)
Always OFF
CAUTION
Wipe off any dirt or grime attached to the lens of
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.
NOTE
To prevent the battery power consumption caused by
forgetting to turn off the LED light, the light goes off
automatically in about 2 minutes.
7. LED light warning signals (Fig. 27)
This product features functions that are designed
to protect the tool itself as well as the battery. While
the switch is pulled, if any of the safeguard functions
are triggered during operation, the LED light will blink
as described in Table 7. When any of the safeguard
functions are triggered, immediately remove your
fi nger from the switch and follow the instructions
described under corrective action.
Fig. 27
Table 7
Safeguard Function LED Light Display Corrective Action
Overload protection
On 0.1 second/off 0.1 second
Remove the cause of the overburdening.
Overheat protection
On 0.5 second/off 0.5 second
Allow the tool and battery to thoroughly cool.
21
English
00BookC3607DANA.indb2100BookC3607DANA.indb21 2018/04/1618:00:092018/04/1618:00:09