Use And Care Manual
16
English
PRACTICAL APPLICATIONS
WARNING: * To avoid personal injury, never remove or place a workpiece on the table while the tool
is being operated.
* Never place your limbs inside of the line next to warning sign while the tool is being
operated. This may cause hazardous conditions (see Fig. 23).
Fig. 23
Warning sign
Line
Warning sign
Line
1. Switch operation
The tool will not start unless the Lock-off button is pressed while the switch is
pulled back.
The Lock-off button can be engaged by pressing it from the left.
After the switch is on, the saw blade will continue to operate as long as you
pull on the switch trigger, even if you release the Lock-off button.
When the switch is released, the Lock-off button automatically disengages to
prevent inadvertent motor startup.
WARNING: Never lock the Lock-off button in depressed position.
Pulling back the switch would then cause the tool to suddenly start operating, which
could result in injury.
2. Using the Vise Assembly (Standard accessory)
(1) The vise assembly can be mounted on either the left fence
{Fence (B)} or the right fence {Fence (A)} by loosening the 6mm
wing bolt (A).
(2) The screw holder can be raised or lowered according to the
height of the workpiece by loosening the 6mm wing bolt (B).
After the adjustment, fi rmly tighten the 6mm wing bolt (B) and fi x
the screw holder.
(3) Turn the upper knob and securely fi x the workpiece in position
(Fig. 25).
WARNING: Always fi rmly clamp or vise to secure the workpiece to the fence; otherwise the
workpiece might be thrust from the table and cause bodily harm.
CAUTION: Always confi rm that the motor head (see Fig. 1) does not contact the vise assembly
when it is lowered for cutting. If there is any danger that it may do so, loosen the
6 mm wing bolt (B) and move the vise assembly to a position where it will not contact
the saw blade.
Fig. 24
Switch trigger
Lock-off button
Fig. 25
Screw holder
Knob
Vise plate
Workpiece
6mm wing bolt (A)
Vise shaft
Fence
6mm wing
bolt (B)
00BookC12LDHUS.indb1600BookC12LDHUS.indb16 2018/11/3016:55:542018/11/3016:55:54