Use And Care Manual
12
English
2. Securing the workpiece
WARNING: Always clamp or vise to secure the workpiece to the fence; otherwise the workpiece
might be thrust from the table and cause bodily harm.
3. Installing the holders ... (Optional accessory)
The holders help keep longer workpieces stable and in place during
the cutting operation.
(1) As indicated in Fig. 9, use a steel square for aligning the upper
edge of the holders with the base surface.
Loosen the 6mm wing nut. Turn a height adjustment bolt 6mm,
and adjust the height of the holder.
(2) After adjustment, fi rmly tighten the wing nut and fasten the holder
with the 6mm wing bolt (optional accessory). If the length of
Height Adjustment Bolt 6mm is insuffi cient, spread a thin plate
beneath. Make sure the end of Height Adjustment Bolt 6mm does
not protrude from the holder.
4. Stopper for precision cutting ... (Stopper and holder are optional accessory)
The stopper facilitates continuous precision cutting in lengths of 11" to
17-3/4" (280mm to 450mm).
To install the stopper, attach it to the holder with the 6mm wing bolt as
shown in Fig. 10.
5. Confi rmation for use of sub fence (A)
WARNING: In the case of right bevel cutting, turn the sub fence (A) clockwise. Unless it is turned
clockwise, the main body or saw blade may contact the sub fence (A), resulting in
an injury.
This power tool is equipped with a sub fence (A).
In the case of direct angle cutting and left bevel angle cutting,
use the sub fence (A). Then, you can realize stable cutting of the
material with a wide back face.
In the case of right bevel cutting, raise the sub fence (A) up as
illustrated in Fig. 11 and then turn it clockwise.
6. Confi rmation for use of sub fence (B)
WARNING: In the case of left bevel cutting, turn the sub fence (B) counterclockwise. Unless it
is turned counterclockwise, the main body or saw blade may contact the sub fence
(B), resulting in an injury.
This power tool is equipped with a sub fence (B). In the case of
direct angle cutting and right bevel angle cutting, use the sub
fence (B). Then, you can realize stable cutting of the material with
a wide back face. In the case of left bevel cutting, raise the sub
fence (B) up as illustrated in Fig.12 and turn it counterclockwise.
6mm wing bolt
(optional accessory)
Steel square
6mm wing
nut (optional
accessory)
Height adjustment
bolt 6mm (optional
accessory)
Holder
(optional
accessory)
Base surface
Fig. 9
Fig. 10
Stopper
(optional accessory)
Holder
(optional accessory)
6mm wing nut (optional accessory)
Height adjustment bolt 6mm (optional accessory)
6mm wing bolt
(optional accessory)
Workpiece
Fig. 11
Sub Fence (A)
Turn
Left bevel angle cutting
Direct angle cutting
Right bevel
angle cutting
Fence (A)
Turn
Left bevel angle
cutting
Right bevel angle cutting
Direct angle cutting
Sub fence (B)
Fence (B)
Fig. 12
00BookC12LDHUS.indb1200BookC12LDHUS.indb12 2018/11/3016:55:532018/11/3016:55:53