Use and Care Guide

10
English
STANDARD ACCESSORIES
(1) Bull Point (SDS max shank) (Code No. 313471)......1
(2) Case (Code No. 373405) ........................................1
(3) Side Handle (Code No. 330209) .............................1
OPTIONAL ACCESSORIES ……sold
separately
○
Demolishing
(1) Bull Point (SDS max shank type)
Overall Length 11-1/32” (280 mm) 15-3/4” (400 mm)
Code No. 313471 313472
○ Groove digging and edging
(1) Cold chisel (SDS max shank type)
Overall Length 11-1/32” (280 mm) 15-3/4” (400 mm)
Code No. 313473 313474
○ Asphalt Cutting
(1) Cutter (SDS max shank type)
Overall Length 15-3/4” (400 mm)
Code No. 313475
○ Scooping Work
(1) Scoop (SDS max shank type)
Overall Length 15-3/4” (400 mm)
Code No. 313476
○ Surface Roughing
(1) Bushing Tool
(Code No. 313477)
(2) Shank
(Code No. 313479)
+
○
Tamping
(1) Rammer
(Code No. 313478)
(2) Shank
(Code No. 313479)
+
○
Hammer Grease A
30 g (in a tube) (Code No. 981840)
70 g (in a tube) (Code No. 308471)
NOTE:
Specifi cations are subject to change without any obligation
on the part of the metabo HPT.
ACCESSORIES
WARNING
ALWAYS use Only authorized metabo HPT replacement parts and accessories. NEVER use replacement
parts or accessories which are not intended for use with this tool. Contact metabo HPT if you are not sure
whether it is safe to use a particular replacement part or accessory with your tool.
The use of any other attachment or accessory can be dangerous and could cause injury or mechanical
damage.
NOTE:
Accessories are subject to change without any obligation on the part of the metabo HPT.
000BookH41MB2.NA.indb10000BookH41MB2.NA.indb10 2018/05/1710:38:322018/05/1710:38:32