3-PIECES CD SHELF SYSTEM with Digital PLL AM/FM Stereo Radio and Bluetooth® Wireless Technology OWNER'S MANUAL PLEASE READ BEFORE OPERATING THIS EQUIPMENT. MODEL: MM435M Size: 148.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, AND ANNOYING INTERFERENCE, USE THE RECOMMENDED ACCESSORIES ONLY. The users manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
5
LOCATION OF CONTROLS 1 2 34 5 6 7 8 9 10 11 12 13 25 26 24 14 15 16 17 18 20 21 22 23 6 19
1. CD DOOR 14. VOLUME Control Knob 2. CD Door OPEN (Close) Area 15. AL SET (Alarm Set) Button 3. POWER Button 16. SLEEP Button 4. FUNCTION Button 17. DIMMER Button 5. REPEAT Button 18. AL ON/OFF (Alarm On/Off) Button 6. PROG (Program) Button 19. DBBS (Dynamic Bass Boost System) Control Knob 7. 20. TIME (Set) Button (Previous/Skip Backward) Button 8. LCD Display 21. MEM- Button 9. (Next/Skip Forward) Button n 10. ■ (Stop) Button 22. MEM+ Button 23. MEMORY Button 11. 24.
Battery Door 5 3 4 1 2 6 1. 3. 2. (Play/Pause) Button (Next/Skip Forward) Button 4. ■ (Stop) Button (Previous/Skip Backward) Button 5. REPEAT Button 6.
CONNECTION: Connect the small plug from the Left and Right Speaker Boxes to the SPEAKER OUT L & R Jacks on the rear of main unit as the illustrated below: Right Speaker Box Left Speaker Box POWER SOURCE: Main Unit: Unwind the AC power cord and extend it to its full length.
Notes: This unit is equipped with a polarized AC plug which has one blade wider than the other. This is a safety feature to reduce the likelihood of electric shock. This polarized AC plug will only fit in a polarized AC outlet. If you find that you cannot insert this plug into your outlet, you may have an obsolete non-polarized outlet. Please do not try to defeat this safety feature by using a non-polarized adaptor or by filling the wider blade to make it fit into your outlet.
REMOTE CONTROL: First time use: Remove and discard the insulation film as the illustrated follows: Insulation Film Replacing the button cell when it is drained: Push and slide out the battery holder as the illustrated below. Replace the button cell with new CR2025 button cell as the polarity markings on the rear of the Remote Control. Close the battery holder. Push here CR2025 Slide out BATTERY PRECAUTIONS: Follow these Battery Precautions when using a battery in this device: 1.
possible battery leakage. 5. Do not try to recharge the battery not intended to be recharged; it can overheat and rupture. (Follow battery manufacturer’s instructions.) 6. Do not dispose of battery in fire. Battery may explodes or leak. 7. Clean the battery contacts and also those of the device prior to battery installation. 8. ⚠ This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burn in just 2 hours and can lead to death.
OPERATION GENERAL OPERATION: 1. 2. 3. Connect the unit to AC power as previously instructed. The unit will enter to standby mode automatically and the LCD Display will illuminate. Press the POWER Button on the main unit or remote control to turn on the unit from standby mode. The POWER Indicator will illuminate. Press the FUNCTION Button on the main unit or remote control repeatedly to switch to desired playback mode.
)
Snooze: When the alarm sounds, tap the SNOOZE BUTTON to temporarily turn off the alarm and activate the snooze function, the alarm will stop and sound again 9 minutes later. If you tap the SNOOZE BUTTON again, the alarm will temporarily turn off again and sound again in 9 minutes and so on. CD: CD Playback: 1. 2. 3. 4. Open the CD door by press the CD OPEN (Close) area. Place a CD disc on the center spindle, with the printed label side up. Close the CD Door by press the CD OPEN (Close) area.
1. In CD stop playing mode, press the PROG (Program) Button on main unit or remote control. “P01” will appear on the display and PROG indicator will blink. 2. Select the first specific track to be programmed by pressing the 3. 4. 5. Forward) or (Previous/Skip Backward) Buttons on the unit or Remote Control repeatedly. Press the PROG Button again to store the selected track into the memory. Repeat steps 2 and 3 until all the specific tracks stored into the memory.
AUX IN: 1. Connect the external Audio Device with a 3.5mm AUX cable. (Cable not included). 2. Insert one end of the AUX cable to the Phone; Line Out or AUX Out Jack on the external Audio player. 3. Power on the unit from Standby mode by press the POWER Button on the unit to select AUX In mode. Insert the other end of the AUX cable into the AUX In Port on the front of unit. “AUX” indicator will appear on the display. Play the music on the connected Player as usual.
TROUBLESHOOTING Check the following before requesting service: SYMPTOM No power POSSIBLE CAUSE AC Power cord had not connected POSSIBLE SOLUTION Plug the AC Cord to any wall outlet having AC 120V~; 60Hz Volume of the unit was set to minimum Increase the volume level by position turning the VOLUME Control Volume level of paired/connected Rise the volume level of the device is in low level paired/connected device Volume level too high Reduce the volume level by No sound or sound weak Knob clockwi
SPECIFICATTIONS Power Source: Clock Back Up: BT Version: AC 120V~; 60Hz; 18W DC 3V; 2 x “AAA” size batteries (Not included) 5.0 BT Operation Distance: <=32 Feet in open area Radio Frequency: AM: 520-1710kHz FM: 87.
LIMITED WARRANTY Craig Electronics warrants this product to be free from manufacturing defects in material and workmanship under normal use for a period of 180 days from date of purchase.