User's Guide

Waterproof Wireless Speaker
User’s Guide for Model ISBW108 v2842-01
Protect for Today
Sustain for Tomorrow
Made
Green
Copyright © 2021 Digital Products International (DPI, Inc.)
All other trademarks appearing herein are the property
of their respective owners.
Contact Information
Website: www.iLiveElectronics.com
Email Support: [e-mail]
Email Parts: [e-mail]
Phone Support: 1-888-999-4215
Warranty
For Warranty Information and the most
up-to-date version of this User’s Guide, go to:
www.iLiveElectronics.com.
FCC WARNINGS
ADDITIONAL WARNINGS
•
this unit to rain or moisture.
• WARNING : Where the mains plug or appliance coupler is
used as the disconnect device, such disconnect device shall
remain readily operable.
• Lithium batteries, like all rechargeable batteries, are
recyclable and should be recycled or disposed of according to
state and local guidelines. They should never be disposed of in
normal household waste and they should never be incinerated,
as they might explode. Contact your local government for
disposal or recycling practices in your area.
• To avoid hearing damage, make sure that the volume on
your music player is turned down before connecting your
earbuds or headphones. After placing earbuds in/on your ears,
gradually turn up the volume until you reach a comfortable
listening level.
WARNING: This product can expose you to chemicals
including lead, which is known to the State of California
to cause cancer and birth defects or other reproductive
harm. For more information go to www.P65Warnings.
ca.gov. This product meets and complies with
required Federal product guidelines
Aux In (3.5mm Audio Input)
1. Connect a 3.5mm audio cable (not included) to
the Aux In on the unit and the audio output/
headphone jack on a media player.
2. The unit will automatically detect the input and
switch to Aux In Mode, indicated by a voice
prompt and a slowly blinking indicator light. Use
the controls on the connected device to select and
play audio.
Previously Connected Devices
• The speaker can remember multiple Bluetooth
devices and will always try to re-connect to the
last device used.
•
Bluetooth on unwanted devices, then access the
Bluetooth settings menu on the device you wish
to use and select ISBW108.
• If the speaker should become unpaired or will
not connect normally, follow these steps in your
device’s Bluetooth Settings Menu.
» Delete the speaker (“Forget This Device”).
» Turn Bluetooth OFF then ON again, and
repeat the Initial Bluetooth Connection.
ISBW108-2842-01-IB.indd 1-5 13/07/2021 10:53:56 AM
This equipment may generate or use radio frequency energy.
Changes or modifications to this equipment may cause harmful
interference unless the modifications are expressly approved in the
instruction manual. The user could lose the authority to operate this
equipment if an unauthorized change or modification is made.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure
requirement. The device can be used in portable exposure condition
without restriction.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• The rating information is located at the bottom of the unit.