BLUETOOTH 50 WATT CD SHELF SYSTEM OWNER'S MANUAL PLEASE READ BEFORE OPERATING THIS EQUIPMENT.
LIMITED WARRANTY FCC WARNING: This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. Modifications not authorized by the manufacturer may void users authority to operate this devices. INFORMATION: This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of the FCC Rules.
2
CARE AND MAINTENANCE Depending on the quality of the disc, and the condition of the recording, some CD-R/CD-RW discs may not be playable. How to remove the disc How to hold the disc How to clean the disc 1. Always place the compact disc in the disc tray with the label facing upward. (Compact discs can be played only on one side). 2. To move a disc from its storage case, press down on the center of the case and lift the disc out, holding it carefully by the edges. 3.
LOCATION OF CONTROLS MAIN UNIT 20 21 10 20 7 5 50 3 10 100% 1 10 20 2 3 0 7 5 3 50 10 100% 18 19 1 2 3 0 ST 1 2 3 FM 17 MHz PHONES 4 5 6 7 8 9 10 11 12 13 14 15 22 16 23 24 DC 15V 1. 2. 3. 4. 5. 6. 7. 8. 9. 10 11. IR STANDBY PHONES JACK AUX IN JACK SOURCE BUTTON BALANCE KNOB STOP BUTTON / TUN- BUTTON TREBLE KNOB SCAN / PAIR BUTTON / TUN+ BUTTON 12. 13. 14. 15. 16. 17. 18. 19.
REMOTE CONTROLS 1 10 2 11 3 CD FM BT AUX 12 4 PROG MEM MEM MEM 13 14 15 16 17 5 6 OPEN/ CLOSE REPEAT SCAN 7 TUN TUN 18 19 20 8 21 9 PAIR CLK SET 1. 2. 3. 4. 5. 6. 7 & 18. 22 FM BUTTON: Set the unit to FM radio mode STANDBY BUTTON: Set the unit to ON/ STANDBY CD BUTTON: Set the unit to CD mode PROG BUTTON: CD program playback MEM BUTTON: Radio memory REPEAT BUTTON: Set playback to repeat. TUN- / , TUN+ / : Adjust the frequency in FM mode.
The Remote Control Unit can operate the unit from a distance about 8M. When operating the remote control unit, point it towards the front panel of the unit. • Even if the remote control unit is operated within the effective range, remote control operation may be impossible if there are any obstacles between the unit and the remote control.
CONNECTION AND POWER SOURCE CONNECTING THE EXTERNAL SPEAKERS The speaker input sockets are located at the back of the main unit. Speaker output sockets are located at the back of speaker box. 1. Unwrap the included speaker wire, plug one end into the left (L) speaker box and plug the other end into the left (L) speaker socket on the main unit. 2. Unwrap the included speaker wire, plug one end into the right (R) speaker box and plug the other end into the right (R) speaker socket on the main unit. 3.
OPERATION FM RADIO 1. Press the SOURCE button to switch to the FM RADIO or press the FM button on the remote. The display will show a radio station. 2. Tune to a desired radio station. The frequency is indicated on the display. • MANUAL TUNING: Press the TUN+ or TUN- button briefly and the frequency will tune up or down. • AUTO SEARCHING: Press the TUN+ or TUN- button for more than 2 seconds, the radio frequency will start to change on the display.
CD 1. Press SOURCE button until the display reads “CD” or press CD button on the remote. 2. Press the OPEN/CLOSE button to open the CD door, put a CD onto the CD tray with the printed label facing up (towards you). To close the CD door, press OPEN/CLOSE button again. Note: Remember to remove the CD when you are finished listening. To Play a CD When Stopped: Press the /PAIR button. The disc will play from track 1 and play indicator appears on the display. To Pause a CD While Playing: Press the /PAIR button.
ATION AUX-IN External (auxiliary) audio sources such as tablets, smartphones or MP3 players, can connect to the Bluetooth 50 Watt CD Shelf System via aux-in. 1. Press STANDBY button to turn the unit ON and then press SOURCE button to select “AUX” or press AUX button on the remote. 2. Set the volume to the minimum level with the VOLUME KNOB. 3. Plug in an AUX-IN cable (not included) into the AUX-IN jack on the front of the unit. 4.
TROUBLESHOOTING In case of trouble with the unit, please look through the problems below and see if you can solve them yourself before calling your dealer. PROBLEM BLUETOOTH CD PLAYER RADIO UNIT WHOLE UNIT Unit does not turn ON when STANDBY is pressed. CAUSE SOLUTION • Unit is unplugged • Connect unit to AC power supply No sound comes out of the speakers. • The external speakers are disconnected. • The volume is turned down (to MIN). • The input selector does not match the playback source.
ATIONS GENERAL SPECIFICATIONS Power Source : DC 15V, 3A, Audio Power : 25W per Channel (Total 50W, RMS) Impedance of Speakers : 30W, 4 ohm per channel FM Band Range : 87.5 - 108MHz BT Version : 5.
LIMITED WARRANTY Craig Electronics warrants this product to be free from manufacturing defects in material and workmanship under normal use for a period of 180 days from date of purchase.
