User manual

2. Camera Installation
10 NDF821/NDF821E l User Manual
2.3 Mounting the Camera
1. Insert the plastic anchors into the screw holes (this gure take the tapping type screws as the
example to illustrate the mounting).
2. Use the tapping screws to secure the camera base to the surface.
Guide Pattern Sticker
1. Machine Type Screws
2. Inner Liner
3. microSD/SDHC Card
TipCautionWarning
Note
1. While you are securing the camera with the accompanying screws, please be advised to hold the
camera by its base. Do not hold the lens or lens base with force that may deform the lens.
2. Use the machine type screws if you are attaching the camera to a pendent mounting. Use the
tapping type screws for all other surfaces.
3. For cement surfaces, insert the “Plastic Anchors” into the holes. For softer surfaces, do not use
the “Plastic Anchors”.
4. Use the Rubber Feet for surface mounting.
2.4 Wiring the Cables
Draw out the cabling to the corresponding destination. Please refer to the Connector section.
1. Connect the camera to a power source, using one of these options:
•
DC 12V or AC 24V:
Connect to the power terminals on the rear panel. If using DC 12V power
supply, make sure polarities (Red+/White–) are correctly wired.
•
PoE:
Attach the RJ-45 connector to a PoE compliant network device. Power will be supplied
through the Ethernet cable.
2. Attach the BNC connector to a monitor for composite video output.