User manual

6
Push and hold TEST pushbutton: system starts test and programming
check cycle then, after about 10 seconds, switches OFF all leds.
Release TEST button after leds switch off: the system enters the
programming mode and begins step 1 of the programming sequence.
During programming sequence, push CANCEL HOOTER to select the
desired option, push TEST to confirm current setting and jump to next step;
Programming sequence
Step
Prg
Function
User
Interface
First Option
(default)
Second Option
Third
Option
1
Input 1
Operation
Led 1 Æ
Normally Open
fixed lighted
Normally Closed
fast blinking
-----
2
Input 1
Delay
Led 1 = ON
Buzzer Æ
No delay
Short buzz
Delay 5 sec
Long buzz
-----
3
Input 2
Operation
Led 2 Æ
Normally Open
fixed lighted
Normally Closed
fast blinking
-----
4
Input 2
Delay
Led 2 = ON
Buzzer Æ
No delay
Short buzz
Delay 5 sec
Long buzz
-----
5
Input 3
Operation
Led 3 Æ
Normally Open
fixed lighted
Normally Closed
fast blinking
-----
6
Input 3
delay
Led 3 = ON
Buzzer Æ
No delay
Short buzz
Delay 5 sec
Long buzz
-----
7
Input 4
operation
Led 4 Æ
Normally Open
fixed lighted
Normally Closed
fast blinking
-----
8
Input 4
Delay
Led 4 = ON
Buzzer Æ
No delay
Short buzz
Delay 5 sec
Long buzz
-----
----- ----- ----- ----- ----- -----
9
(17)
Buzzer
Operation
All leds OFF
Buzzer Æ
Continue mode
Continue tone
Pulse mode
Pulse tone
Disabled
OFF
10
(18)
Relay OUT
Operation
All leds = ON
Buzzer Æ
Buzzer repeater
Pulse tone
Cumulative Alarm
OFF
-----
EXIT from PROGRAMMING MODE - RETURN to RUNNING MODE
The exit from Programming Mode occurs at the end of the programming
sequence or by the 30-seconds key-timeout.
The exit by timeout also preserves all previous changes, except for
those corresponding to the current input.
For example: if timeout occurs while the system stands in step 8, only
previous modifications concerning the inputs 1, 2 and 3 will be preserved.
On the contrary, the exit by timeout does not recover a
NO / INVALID
SETUP PARAMETERS
condition (refer to corresponding section).