Instructions / Assembly

03
12
WS-300/A
(C )onnecting seal
300/300A ACCESSORIES
(Other models can refer to this model)
(F )ixed glass door and sliding glass door
(P )lastic seal
(G )lass door seal
(Plastic pad)
I. Instructions
1. Capacitor touch buttons are adopted in this panel. In selecting the position to
install the panel, we should avoid facing directly the spray and shower nozzle,
otherwise it may lead to mistaken operation of the panel or locking the panel;
2. The location area of each function button on the panel is the optimum touch
range;
3. The panel is optimized with waterproof function. When mistaken operation is
tested (with two or more keys touched simultaneously), there will be no response.
Wait for about 1 second to restore operation.
4. Under the status of panel locking, the system gives no response when touching
the panel, and the icon flickers on the LCD. At this time, touch the key for
two seconds, and the locking will be released. Meanwhile, the icon goes off on
the LCD, and you can operate the keys on the panel.
5. When touching any key on the panel, the operating system will give a “beep”
tone if the system operation is enabled.
1.Lamp function; 2.Fan function; 3.Steam function;
4.Radio function 5.Telephone function; 6.Failure code indication;
7.Ozone disinfection after turning off; 8.Alarm function
II. Introduction to Functions
III. Method of Operation
(I) Turn on/off the machine
1. Standby mode
The system is in standby mode after power on, and a red dot will be displayed on the
screen to indicate connected power.
2. Turn on the machine
When the system is in standby mode, touch and hold the button for two seconds to
start the machine and the current temperature will be displayed on the screen, such as
. At the same time, the ceiling lamp will light up. When the machine is
started, it is timed for 60 minutes and the machine will shut off automatically when
the time is due.
3. Turn off the machine
Either the button on the touch panel is touched or the default set time (60 minutes)
is up, the machine will be turned off, and all the activated functions will be
disenabled, and the system will go back to the standby mode. After the system is
turned off for 30 seconds, the automatic water discharge function will be started
automatically.