Instructions / Assembly

ManualsBrandsMESA ManualsBath47 in. x 35 in. x 86 in. Left Sided Steam Shower Enclosure Kit

Table Of Contents

Sanitary Ware Expert

Your best choice!

WS-300

WS-301

WS-302

WS-300A

WS-301A

WS-302A

No advanced advice will be submit before we change our design and size.

The pictures may be a little different from the real products.

Our company keep the final explanation right.

Do not dispose this product as unsorted municipal

waste. Collection of such waste separately for special

treatment is necessary.

BREAKDOWN PHENOMENON AND SETTLEMENT

Without steam

1.steam generator without water

2.inside infrared pipe burn out of steam generator

3.block of steam spray mouth

4.probe out off control

5.the temperature inside steam room is over the

temperature what were set

6.after fill into water it is still not the time for

steam working

7.it is overtime for the setting time

8.unconnect with the control wire

1.check if the switch of water in be

turn on or not.

2.change the infrared pipe.

3.get rid of mess.

4.check the connection wire and

change the probe.

5.waiting decrease the temperature.

6.be waiting few minutes.

7.adjust the setting time.

8.connect to control wire.

Phenomenon

Reasons

Maintenance

Water pipe

leaking

1.plastic seal ring be connected untightly.

2.screws unlock.

3.connection is glued not good.

4.water pipe be damaged.

1.change the plastic seal ring.

2.screws should be installed tightly.

3.get rid of the PVC glue then stick

the glue again till it is be well done.

4.change the water pipe.

Computer panel

under control

1.power not be connected well,electronic

leakage device without power.

2.switch of control panel out of control.

1.get through the power again.

2.change the computer panel.

1.change bulb.

2.get through power gain.

3.maintain or change the computer

panel.

1.bulb be burned.

2.without power.

3.switch of control panel out of control.

Without lighting

Telephone

connection

unworking

1.telephone wire not connected well or be

damaged.

2.telephone's device be blocked.

1.check the wires of telephone and

electronic box if get through or not,

if there is something wrong replace

by the similar wires.

2.get rid of mess.

Without sounds

1.speaker be broken

2.without power

3.switch of control panel out of control

1.change the speaker

2.get through power again

3.maintain or change the computer

panel

Summary of content (8 pages)

PAGE 1
BREAKDOWN PHENOMENON AND SETTLEMENT Phenomenon Without steam Reasons Maintenance 1.steam generator without water. 2.inside infrared pipe burn out of steam generator. 3.block of steam spray mouth. 4.probe out off control. 5.the temperature inside steam room is over the temperature what were set. 6.after fill into water it is still not the time for steam working. 7.it is overtime for the setting time. 8.unconnect with the control wire. 1.check if the switch of water in be turn on or not. 2.
PAGE 2
Dear users: Thanks for choosing our products, for the purpose of safety, please read this manual carefully before use. The instruction manual be the same with the following steam room: ATTENTIONS WS-300/300A、 WS-301/301A、 WS-302/302A、 WS-303/303A、 WS-304/304A、 (VII) Failure Alarm Code This machine has autonomous failure detection function.
PAGE 3
(II) Alarm function when the machine is turned on , touch the button 3seconds on the panel to turn on alarm function, the screen showing ,meanwhile ,turn off steam function and radio function , and turn on fan function and lamp function .The speaker will be sound the alarm .After touch the button turn off the alarm will relief the alarm. (II) Lamp function When the machine is turned on, touch the button the ceiling lamp.
PAGE 4
I. Instructions 300/300A ACCESSORIES (Other models can refer to this model) (Plastic pad) (Glass door seal) 1. Capacitor touch buttons are adopted in this panel. In selecting the position to install the panel, we should avoid facing directly the spray and shower nozzle, otherwise it may lead to mistaken operation of the panel or locking the panel; 2. The location area of each function button on the panel is the optimum touch range; 3. The panel is optimized with waterproof function.
PAGE 5
(Glass rack) E S B (Hand-held shower) A (Nail) 1、On/Off function key 6、Lamp/Alarm function key 2、Fan function key 7、Steam function key 3、Steam adjustment function key 8、Radio tuning function key 4、Radio/Telephone receive function key 9、Radio memory key 5、Parameter setting decrease key 10、Parameter setting increase key A、Fan function indicator B、Steam function indicator 11 (Hinge) WS-300/A 04
PAGE 6
Model:WS-300(clear glass) Model:WS-300A(blue glass) Size:1200X900X2150mm 1200 900 850 345 600 Model: WS- 301(clear glass) Model:WS-301A(blue glass) Size:900X900X2150mm 1000X1000X2150mm 900 8、Install the gliding glass door 1.Adjust the tray to be horizontal by a horizontal meter. 2.Fasten the up and down nail (no space left), at the same time keep the back and side glass body vertical to the tray. 3.Fix the hinge onto the fixed glass door, make it be horizontal to the tray. 4.
PAGE 7
6、Install the glass top (G l s as (S id e to a gl (N p) ss go dy ut Model:WS-30 3 (clear glass) Model:WS-303A(blue glass) Size:800X800X2150mm 900X900X2150mm 1000X1000X2150mm ) ) (G las st op ) (G ( r Sc e k as wM 6X (N et) ) 20 ut (S e id gla s o sg dy ) Model:WS-30 4 (clear glass) Model:WS-304A(blue glass) Size:750X900X2150mm 800X1000X2150mm 800X1200X2150mm ) 7、Fix the nail ) ( (G ( d Si eg a e sk las r Sc ew M 16 ) c (S t) o sg 6X dy ( ) a Tr
PAGE 8
INSTALLATION PROCESS OF 300/300A (Other models can refer to this model) 4、Install the right body 1、Install the bottom tray: If the ground is not horizontal, please regulate the screw of the bottom tray , make the bottom tray and ground keep competence.