Use and Care Manual

8
Slot #4 : Audit Function
Input: 0 to disable Audit Function
Input: 1 to activate Audit Function
9
Slot #5 : Locking Function
Input: 1 to place the lock into Standard Lock Mode
If Standard Lock Mode is selected:
!
The 1
st
code/card you use to lock the safe will be the set code/card
@
Once the code/card is set, you only need to input
#
to lock the safe
#
You will need to input your set code/card to unlock the safe
$
To change your set code/card, you will need to go back into the Lock
Settings [Refer back to Changing the Lock Settings]
%
Place the lock function into Hotel Lock Mode
^
Go back into the Lock Settings
&
Place the lock into Standard Lock Mode
*
Repeat Steps 1-8
Input: 2 to place the lock into Hotel Lock Mode
[ This is the default mode]
0
Slot #6 : Unused Slot
Input: 1 if not already entered. This slot does not disable or activate any
functions
Input:
#
to confirm the 1
st
set of Lock Settings & move forward to the 2
nd
set of Lock Settings
If you do not want to make any changes to the 2
nd
set of Lock Settings,
input
#
again
The 2
nd
set of Lock Settings
The 2
nd
6-digit number [default setting: 4 7 1 5 4 0 ] is now displayed & Slot
#1 is ‘Blinking’
Slot #1 : Invalid Entry
Input a number from 1-9 digits to set the number of times allowed for
entering an invalid code or card before placing the lock into the Lock-Out
Penalty
Slot #2 : Code Length
Input 3 to set the code length to a 3-digit code
Input 4 to set the code length to a 4-digit code
Input 5 to set the code length to a 5-digit code
Input 6 to set the code length to a 6-digit code
Input 7 to set the code length to a 3-6 digit code
PG.6
|
MH-SERIES ELECTRONIC LOCK INSTRUCTIONS