Use and Care Manual

Changing the Override Card
NOTE : The safe must be in the unlocked position
1
Input:
*
-
*
; [[ PROG ]] will appear on the display
2
Input: 7 2 6 2 4 8
- #
; [[ C A R D ]] will appear on the display
3
Swipe the card you wish to set as the new Override Card; [[ GOOD ]] will
appear on the display. The Override Card has been successfully changed
CHANGING THE LOCK SETTINGS
Changing the Override Code
NOTE : The safe must be in the unlocked
position
1
Input:
*
-
*
; [[ PROG ]] will appear on the display
2
Input: 7 1 1 4 6 9
- #
; [[ CODE ]] will appear on the display followed by a
6-digit number
4
The 1
st
6-digit number is now displayed & Slot #1 will be ‘Blinking’ [Slots:
refer to graph]
Default setting is: 1 1 1 1 2 1
To advance to the next Slot without making changes to the current Slot,
enter the number displayed in the current Slot
Input
#
if you do not want to make any changes to the 1
st
6-digit number
& would like to move on to the 2
nd
6-digit number
Input:
*
if you would like to start over & go back to Slot #1
5
Slot #1 : Entry Display
Input: 0 to disable Entr y Display. The numbers entered will not display
Input: 1 to activate Entry Display. The numbers entered will display
When Entr y Display is activated, Input :
*
before entering code & the
numbers entered will not display for added security
6
Slot #2 : Code Display
Input: 0 to disable Code Display. The code entered will not be displayed
after the safe is locked
Input: 1 to activate Code Display. The code entered will display for 2
seconds after the safe is locked
7
Slot #3 : Hide Button
When Entr y Display is activated, Input :
*
before entering code & the
numbers entered will not display
Input: 0 to disable Hide Button function
Input: 1 to activate Hide Button function
MH-SERIES ELECTRONIC LOCK INSTRUCTIONS
|
PG.5
0 0 0 0 0 0