Use and Care Manual

USING THE OVERRIDE FUNCTIONS
If [[ E-Code ]], [[ E-Card ]] or [[ ERROR ]] appear on the display after entering
your code or swiping your card to unlock the safe, you will need to use the
Override Code, Override Card or Override Keys
If [[ E-BAR ]] appears on the display, you will need to use the Override Keys
Using the Override Code
1
Input :
#- #
; [[ SUPER ]] will appear on the display [do not pause between
#- #
entries]
2
Input : Override Code; the safe will unlock
The default Override Code is: 0 0 0 0 0 0
IMPORTANT : Because the codes are factory set, we highly recommened
changing the codes to your own unique codes immediately!
Using the Override Card
1
Swipe the Override Card, the safe will unlock
[See Changing the Override Card to set your card]
Using the Override Keys
1
Locate the small round cap just below the right side of
the keypad [Override Key Hole; refer to graph]
2
Using the allen wrench (included), remove the cover
[for MH101 Model, simply remove the cap with your
finger tips]
3
Inser t the Override Key & turn clockwise, a ¼ turn &
open door
4
To remove the key, turn the key counter-clockwise, a ¼
turn, back to the inser ted position
IMPORTANT : Do NOT store the Override Keys in the safe!
CHANGING THE OVERRIDE
Changing the Override Code
NOTE : The safe must be in the unlocked position
1
Input:
*
-
*
; [[ PROG ]] will appear on the display
2
Input: 8 4 2 6 2 7
- #
; [[ OLD ]] will appear on the display
3
Input: Override Code
- #
; [[ NE W ]] will appear on the display
The default Override Code is: 0 0 0 0 0 0
4
Input a new 6-digit code
- #
; [[ AGAIN ]] will appear on the display
5
Re-Input the new Override Code
- #
; [[ GOOD ]] will appear on the display.
The Override Code has been successfully changed
PG.4
|
MH-SERIES ELECTRONIC LOCK INSTRUCTIONS
mesa
mesa