Use and Care Manual

THE ANCHOR KIT
To maximize the security of your safe, ME S A recommends using the anchor kit
[provided] to bolt down your safe. The safe can be anchored to a wall, floor,
etc., or a ME S A Model MP-Pedestal [see ME SASA F E .COM for more info].
1
Choose a suitable & convenient location for you safe. Set the safe in place
& locate the anchor holes provided on the safe to mark the area to be
drilled on the wall, floor, desk, etc.
If bolting your safe to a wall, please ensure that the safe is resting on a
supporting surface; i.e., floor, table, shelf.
2
After mark ing the drill spots, move the safe aside and drill holes of the
appropriate diameter & depth for the type of hardware being used & the
mounting sur face. [Anchor Kit: refer to Checklist for all items included]
3
Place safe back, aligning the anchor holes over the holes drilled, & install
the fasteners as required.
IMPORTANT : If bolting down your safe from the bottom, be sure to
remove the feet pads.
CHANGING THE BATTERIES
1
With the door open, remove the battery compar tment cover located on the
inside of the door by sliding the cover in the direction of the arrow
2
Install 4AA alkaline batteries [included], note the polarity markings (-/+) in
the battery compar tment to ensure proper installation
3
Slide the battery compartment cover back into place
IMPORTANT : Do not use rechargeable batteries, mix alkaline with non-
alkaline batteries, or mix old and new batteries.
MH-SERIES ELECTRONIC LOCK INSTRUCTIONS
|
PG.9